Taxiing on 1 engine

[Paulyg123]

Well it is clear, many of us are eagerly waiting for the MAX in P3D. Hopefully soon....

[Paulyg123]

So, what is the cost of this? I will have one similar like this built for me by Jetline Systems (as soon as PMDG releases a jet for MSFS).

[Paulyg123]

I enjoyed listening to the interview - especially how PMDG got started. I wish they asked more juicy questions. We need Howard Stern to interview R...

[Paulyg123]

Reading thru this thread and RSR comments - did RSR say the 737 for MSFS wont be released until mid or late 2022? Do I read this correctly? If so, I...

[Paulyg123]

Can someone give me a sanity check here? I don't want to get into which is a better sim MSFS or P3D ( I have both - but never use MSFS). but it looks...

[Paulyg123]

You summarized it exactly as I was thinking. For computer sim flying use both engines to taxi as single engine ground physics is not accurate...

[Paulyg123]

ok. We do agree that P3D and FSX don’t give a good flight model for single engine taxi. I will make sure I have both engines running

[Paulyg123]

Kevin: You grew up near KLGA??? I lived right under RW 4 on 78th & street 25 Ave. I went down to RW 4 on my bicycle to watch the planes land and...

[Paulyg123]

I tried some PMDG737 single engine taxiing. I was able to do right and left 90 degree turns with right engine on. So that is good. The 777 is another...

[Paulyg123]

I usually attempt to taxi on 1 engine before takeoff while starting the 2 nd engine. I just find it too hard to do so and end up in the grass. On real...

[Paulyg123]

I find it almost impossible to taxi on 1 engine. The 777 (and 737) pulls very hard to one side and no amount of steering will allow for a straight line....